10
Assembly
Use a known 90° reference (square?) and check
that the table is set square to the sanding disc.
If it is not, reset the table until it is correct
(See fig 8).
Slide the mitre fence into the tables ‘T’ slot.
(See fig 9) Place a 90˚square up against the
mitre fence to make sure it’s perpendicular to the
sanding disc. (See fig 9a) If not, adjust the angle
of the mitre fence until correct, and then reset the
index marker to read 0˚ degrees. (See fig 18)
Fig 9
Fig 9b
Fig 9a
Fig 8
Extraction
port moulding
Scale
Index marker
Square
Mitre fence
Square
Summary of Contents for AWEBDS46 MkII
Page 24: ...24 Maintenance Drive belt Fig 28 Fig 29...
Page 25: ...Parts Breakdown List 25...
Page 26: ...26 Parts Breakdown List...
Page 27: ...27 Parts Breakdown List...
