Axminster 107715, Original Instructions Manual

Page: 19 / 52

Assembly
19
a
40. Locate the micro adjuster (8). Remove the rip fence
assembly from the fence rail (7) and remove the capping
plate from the left side of the fence clamping assembly,
see fig 81.
41. There are two Phillips screws through the micro
adjuster’s mounting bracket with square nuts on them.
Undo the nuts sufficiently to allow them to slide into the
‘T’ slot channel to the side of the rip fence assembly, see
fig 82. Position as required, normally slightly to the right
of the rip fence then tighten the two Phillips screws to
secure the assembly, see fig 83. Replace the capping
plate.
NOTE: making sure the pinion engages into the rack
beneath the fence rail (7).
Micro Adjuster
Fig 81-82-83
Capping plate
Square nuts
‘T’ Slot channel
Pinion
Phillips screw
8
Mitre Fence assembly for sliding Table
42. Locate the mitre fence housing (14), mitre fence
extension (15), locking knob, clamping handle and
workpiece clamp shaft. Replace the mounting bar (a) as
shown in step 33. Insert the Overhead clamp shaft into
the mitre fence housing and secure with a countersink
Hex screw, see fig 84. Lower the mitre fence housing on
top of the mounting bar to the right side of the sliding
table (10). Line up the threaded pre-drilled holes,
introduce the locking knob through the centre hole in
housing (14) and lightly tighten, see fig 85. Insert the
clamping handle through the machined cutout slot in
the housing and into the mounting bar, see fig 86.
Fig 84-85
8
14
Mounting bar
Overhead clamp shaft
Hex countersink screw
Hex key
Locking knob
Continues Over....