Axminster 107715, Original Instructions Manual

Page: 10 / 52

Assembly
10
Fitting the Operating Wheels
8. Locate the two operating wheels (16) and the square
keys. Remove the protective cap from one of the drive
shafts and remove the Hex screw/washer, place safely
aside, see fig 14-15.
Fig 14-15
Drive shaft
Protective cap
9. Insert one of the square keys into the machined slot
on the drive shaft, see fig 16. Line up the machined key
slot to the centre of the hand wheel (16) with the key
and slide the wheel onto the drive shaft. Replace the Hex
screw/washer you removed earlier and tighten securely,
see fig 17-18. Repeat for the other operating wheel.
Hex screw/washer
Fig 16
Square key
Fig 17-18
16
Machined key slot
6. Locate the remaining side panel (2) and four M8 Hex
bolts,washers and nuts (A) and secure in place, see fig 13.
7. Go round and securely tighten all the bolts.
Fig 13
2