Axminster 107674, Original Instructions Manual

Page: 13 / 60

OPERATING INSTRUCTIONS
Fig 26
3. Reposition the belt to one of the five positions on
the pulleys, see figs 26.
MAKE SURE THE BELT IS
INSERTED CORRECTLY INTO
THE PULLEY GROOVES!
Lathe Pulley Speed Chart
Low
High
Spindle
Motor
2400 r
pm
500 r
pm
4080 r
pm
1000r
pm
AW305WL
4. Lower the motor to put tension back on the
pulleys and lock in position. Raise the headstock
cover and close the motor access door.
Pulley grooves
NOTE: The speed chart above
shows approximate speeds
with the lathe off load.
REMOVING THE FACEPLATE
DISCONNECT THE LATHE FROM
THE MAINS SUPPLY BEFORE
CONTINUING!
MAKESURE THE LOCKING PIN
IS IN THE UP POSITION BEFORE
CONTINUING!
You will require two spanners.
Place the first spanner onto the lathe spindle (a)
and the other on the faceplate (b), see fig A. While
holding the first spanner in position, turn the other
anti-clockwise (remember left handed thread) and
remove the faceplate, see fig B.
Fig A
Fig B
13
a a
b b