Axminster 107657, Original Instructions Manual

Page: 9 / 32

Assembly
9
4. Make sure the lathe bed is thoroughly cleaned then replace
the headstock banjo/tool rest and tailstock, replace the stop
pinsto either end of the lathe bed, see fig 16-17-18-19.
Fig 16-17-18-19
Electronic Inverter Control Box
Main Control Box
Fig 20-21-22
Mounting bracket
Inverter control box
Hex screw
Hex key
The main control box has a magnetic base enabling it to be
positioned anywhere on the lathe, see fig 23.
Fig 23
Continues Over....
Locate the inverter control box and two Hex screws. Position
the control box up inside the leg stand (M) and line up the
threaded holes in the mounting bracket with the top two holes
inside the leg stand assembly. Using a Hex key insert the two
Hex screws through the leg stand casting and into the control
box mounting bracket, see fig 20-21-22.