Axminster 107656, Original Instructions Manual

Page: 8 / 72

8
ASSEMBLY INSTRUCTIONS
2. After removing the above lift the lathe bed using a
scissor lift, lifting host or seeking help.
3. Place the stands (F) to each end of the lathe bed
and line up the holes in the stands with threaded
holes in the lathe bed, secure using the 3/8" bolts and
washer (c),see figures 10-11-12-13.
4. Replace the headstock, tool rest and tailstock. (See
figure 14)
Remove the headstock, tool rest assembly and
tailstock from the lathe bed as before to make
it easier to assemble the stands
Figure 10
Figure 11
Figure 12
Figure 13
Use a lifting device as a scissor lift for example to raise the
lathe bed to mount the lathe stands
Figure 14
c
c
Lathe Extension Assembly (Code: 502704)
Assembly 1
The lathe extension (H) bolts onto either end of the
lathe bed which increases the length of the lathe for
turning larger projects. The lathe extension can also
be mounted to the stands for turning large diameter
projects.
1. Locate the lathe extension and centring PIN (H)
and 3/8” Hex bolts, washers (d). Remove the tailstock
stop ROD from the end of the lathe bed, see figure
15 and place safely aside.
2. Insert the centring “PIN” for the lathe bed
extension into the centre hole in the main lathe bed.
Slot the centre hole in the bed extension over the
“PIN” and upagainst the lathe bed, see figure 16. Line
up the holes and secure using the 3/8” Hex bolts and
washers (d), See figure 17.
G
Adjust the feet (G) until the lathe is level
F