Assembly
8
IMPORTANT NOTE: THE HEAD STOCK ASSEMBLY
HAS BEEN LOWERED FOR SHIPPING AND NEEDS TO
BE RAISED TO ITS HIGHEST POSITION. TO DO THIS
INSERT THE LEVER COUPLING OVER THE PINION
ASSEMBLY UNTIL THE TEETH MESH THEN RAISE THE
HEAD STOCK.
2. Re-position the lever (B) coupling over the rack and pinion
assembly so that the lever is in the upright position and the
teeth are meshed together, see fig 08-09.
Fig 08-09
3. Push the lever coupling face up against the support column
and replace the spring and Hex screw washer. Re-tighten using
the Hex key, NOTE: DO NOT OVERTIGHTEN , see fig 10-11.
Fig 10-11
Chuck Compartment
Open the chuck access door by removing the screw and placing
it safely aside. Remove the transport packaging and wipe the
chuck over with a cloth. Close the access door and replace the
screw, see fig 13-14.
Fig 13-14
Chuck access door
Screw
B
Teeth
Teeth
4. Locate the operating wheel (A),
undo the grub screw and slide
the wheel onto the drive shaft
re-tighten the screw, see fig 12.
Fig 12
Grub screw
Shaft
A
