Operating Instructions
14
Fig 14-15
2. Switch on the scroll saw by pressing the ‘GREEN ON’ button,
see fig 15. Adjust variable speed so it’s between ‘Low and High’,
supporting the work piece with both hands slowly guide the
work piece forward into the blade, see fig 16.
Fig 16
NOTE: You must guide the wood into the blade SLOWLY,
because the teeth are very small, and it cuts ONLY on the
downward stroke. If you push the wood into the blade too
rapidly, you can easily break the blade.
NOTE: If you find the blade is struggling to cut through,
increase the speed by turning the variable speed knob.
3. Once you have completed your cut, switch off the scroll saw
by pressing the red ‘OFF’ button.
4. If you have finished using the scroll saw, clean above and
below the work table and wipe the scroll saw over, see fig 17.
Fig 17
DISCONNECT THE SCROLL SAW
FROM THE MAINS SUPPLY!
5. If the scroll saw is not going to be used for
a period of time, use ‘Ambersil Dry PTFE Film
Antistick’, spray, code 952137 over the work
table to prevent the table from rusting and
place a dust sheet over the scroll saw.
1. Loosen the table’s butterfly clamp and
rotate the table to + /- 45˚ degrees and
re-tighten clamp, see fig 18-19.
Tilting the table to 45˚
Fig 18-19
