Axkid Babyfix, Instruction Manual

Page: 7 / 35

6
To adjust the handle: Press both buttons (M) and rotate the handle to the desired position.
The carry handle has 5 positions.
1. Fitting position
2. Carrying position: Make sure handle is locked before lifting and child is harnessed in.
3. Carrying position: Make sure handle is locked before lifting and child is harnessed in.
4. Rocking position or mounted on a compatible stroller.
5. Feeding/non-rocking position.
Positions 2 and 3 can be used whilst fitted in a vehicle if you need to gain better access to your child,
but always return the handle to position 1 as soon as possible.
Positions 4 and 5 should
NEVER
be used whilst fitted in a vehicle
WARNING: ALWAYS ensure your child is harnessed in the baby seat before lifting it.
The harness should exit the child car seat at the same height as the child’s shoulder and should
not exit higher or lower than the child’s shoulder.
WARNING: You should not attempt to adjust the harness height with a child seated in the
child car seat.
Press the belt adjuster button (F) and pull on the shoulder harness straps to create slack.
Press the red release button, unbuckle the harness, move the shoulder straps apart and
remove the shoulder pads.
Unhook the shoulder straps at the rear of the seat shell by sliding the straps through the slits in
the harness connector (L). Remove the straps, pulling them out from the front of the seat.
Pass the shoulder straps back through at one of the three desired heights (K) and reconnect
them to the harness connector.
Buckle up the harness. Connect the two shoulder strap connectors and insert into the buckle.
Ensure harness buckle is firmly clicked into place.
Pull the harness adjuster strap tight and check straps are not twisted.
Adjusting The Carry Handle
Adjusting The Harness Height
3
10
4
5
6
7
8
9