Axis YP3040, Installation Manual, Page: 6 / 132

YP3040 Pan-Tilt Motor
How to Install the Product
Install the Hardware
This installation guide provides instructions for installing the YP3040 Pan-Tilt Motor.
1. Install the wall bracket
2. Install the pan-tilt motor
3. Install the camera in the housing
4. Install the housing on the Pan-Tilt motor
5. Connect the cables
Install the Wall Bracket
1. Prepare the wall for installation of the wall bracket (recommended accessory), use the
supplied drill template to position the holes. Make sure to use drill bits, screws, and
plugs that are appropriate for the material.
Important
To avoid collision, make sure there is enough clearance around the pan-tilt motor and
camera/camera housing (minimum clearance to the ceiling is 60 cm or 24 in. from the top
edge of the wall bracket).
2. Pull the cables through the wall bracket, see Connect the Cables on page 7 .
3. Attach the wall bracket to the wall with the round platform facing upwards.
Important
Make sure to leave enough slack to allow for the cables to twist and bend along with
the unit.
Install the Pan-Tilt Motor
1. Place the pan-tilt motor on the wall bracket, see illustration on page 3 for alignment
and direction of tilt.
2. Secure the pan-tilt motor by tightening the supplied bolts.
Install the Camera in the Housing
Install the camera in the housing according to the instructions in the Installation Guide provided
with the housing. Make sure to allow for the PTZ control cable to pass through the housing to
the camera, see
Connect the Cables on page 7 . For more information, see the Installation Guides
provided with the housing and the camera.
6