Axis YP3040, Installation Manual, Page: 12 / 132

YP3040 Pan-Tilt Motor
Change the DIP Switch Settings
1. Loosen the four side panel mounting screws and remove the side panel.
2. Set the eight switches to select functions. Switches 1, 2, 3, and 4 are used to select the
PTZ control protocol. Switch 7 is always OFF. Switch 8 is used to connect a terminal
resistance of 120
Ω , switch to ON when required.
Select functions
1
2 3
4 5
6
7
8
Protocol Pelco-D
(default)
ON ON OFF OFF
Pelco-P OFF ON OFF OFF
AD/AB
OFF OFF ON OFF
Bit rate 2400 bps OFF OFF
4800 bps ON OFF
9600 bps OFF ON
19200 bps ON ON
Terminal
resistance
OFF (default)
OFF
120 Ω ON
OFF
3. Set the 8 switches to select address.
Select functions
1 2 3 4 5 6 7 8
1 (default)
ON OFF OFF OFF OFF OFF OFF OFF
2
OFF ON OFF OFF OFF OFF OFF OFF
3
ON ON OFF OFF OFF OFF OFF OFF
4 OFF OFF ON OFF OFF OFF OFF OFF
5
ON OFF ON OFF OFF OFF OFF OFF
... ...............................
254
OFF ON ON ON ON ON ON ON
255
ON ON ON ON ON ON ON ON
12