Axis T93E05, User Manual, Page: 7 / 46

AXIS T93E05 User’s Guide Page 7
EN
GLIS
H
Install the hardware
Install the camera in the housing
The instructions below describe how to install an indoor camera in AXIS T93E05 Protective Housing.
For instructions on how to install a corresponding outdoor camera, refer to
Install the wall bracket,
on page 8.
1. Loosen the bottom cover screws and open the top cover, see illustration on page 6.
2. Loosen the holder screw and remove the holder. Discard the o-ring.
3. Secure the camera and holder with the screw according to the illustration below. Tighten the
camera screw to 2 Nm. Be careful not to overtighten the screw.
4. Fit the holder on the bottom cover and adjust its position. Allow just enough distance,
approximately 5–10 mm (0.2–0.4 in.), between the camera lens and the front end of the
housing to fit the top cover without the window scratching the lens.
5. Tighten the screws.
Example image: AXIS M1114 Network camera and AXIS T93E05 Protective Housing
Holder screw (2x)
Camera screw
(remove o-ring)
Holder
O-ring (discard)
Bottom cover
Top cover