Axis T92E series, Installation Manual

Page: 14 / 102

AXIS T92E Housing Series
NO NO
NOTICE
TICE
TICE
Mount the power connector after the power cable is pushed through the cable gasket.
5. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the steps above as applicable to the specific device.
6. Put the bottom cover on the wall mount and tighten the screws (torque 2 Nm).
Install the Camera in the Housing
1. Loosen the holder screws and washers to remove the holder.
2. Secure the camera to the holder with the screws according to the illustrations and table
below. Tighten the stabilizing screw just lightly and tighten the camera screw to 2 Nm.
Be careful not to overtighten the screws
AXIS T92E05/AXIS T92E20 AXIS T92E20 Camera model
Holder position and fasteners
I/O cable
Cold Startup Delay
No
Off (0)
Yes
Off (0)
14