AXIS Q8632-E PT Thermal Network Camera
About PTZ (Pan Tilt Zoom)
Extended Driver Specific Settings
Extended Driver Specific Settings for Video Source 1 allows you to configure the following parameters:
Move Speed -
Enter a value from 1–100 and click
Save
to set the pan/tilt speed.
Nozzle Position -
Select
Nozzle Position
and click
Save
to save the current PT position as the washing position and to enable the
washer button on the Live View page. For information about how to configure the washer see
Configure the Washer on page 27
Washer Configuration -
Enter a value (1 or 2) and click
Save
to select a washer configuration. For more detailed information about
the washer configurations, see
Configure the Washer on page 27
.
Light sensor box -
Select
Light sensor box
and click
Save
to enable the external light sensor.
Calibrate -
Select
Calibrate
and click
Save
to reset camera position if the camera orientation has been changed by outer circumstance.
Image Freeze Mode -
Select
Presets
to freeze the video stream while the camera changes preset position. Select
All
to freeze the
video stream while the camera changes preset position or during manual pan/tilt operation. Select
Off
to disable image freeze mode.
About advanced PTZ settings
Advanced PTZ settings can be configured under
PTZ > Advanced > Controls
.
The
Panel Shortcut Command Buttons
list shows the user-defined buttons that can be accessed from the Live View page’s
Ctrl
panel
. These buttons can be used to provide direct access to commands issued using the VAPIX® application programming interface.
Click
Add
to add a new shortcut command button.
The following PTZ controls are enabled by default:
•
Pan control
•
Tilt control
To disable specific controls, deselect the options under
Enable/Disable controls
.
Note
Disabling PTZ controls will not affect preset positions. For example, if the tilt control is disabled, the product can still move to
preset positions that require a tilt movement.
Configure the Washer
The product can be equipped with an optional washer (not included) to enable cleaning of the protective window.
To enable the washer button on the Live view page and configure the washer:
1. Go to
Live View
.
2. Click
Set emulated joystick mode
, see
About the PT controls on page 12
.
3. Use the joystick to position the washer nozzle in the center of the live view image.
4. Go to
PTZ>Advanced>Device
.
5. Select
Nozzle Position
.
6. In
Washer Configuration
, enter a value (1 or 2) to select the desired washer configuration. Typically select Washer
Configuration 1 if the washer liquid tank is located close to the nozzle. Select Washer Configuration 2 if the washer liquid
tank is located further away from the nozzle. See the table below for more details about the washer configurations.
7. Click
Save
.
27