Axis Q6042, Installation Manual

Page: 22 / 164

AXIS Q60 Series
2. Install the mounting plate. The arrow on the mounting plate will align with the logotype
on the camera.
1
Mounting plate
2
Safety wire
3. Loosen the camera base lid screws and remove the camera base lid.
4. Secure the camera using the supplied safety wire.
5. Route and connect the network cable and, if used, the multi-connector cable to the
camera.
NO NO
NOTICE
TICE
TICE
• Be careful not to damage the cables when connecting them.
• Make sure that the foam gasket holes are aligned with the cable tracks. If using a
multi-connector cable, remove the cut-out piece for the multi-connector cable from
the foam gasket.
1 Cable holders
2
Multi-connector cable
3 Network cable
6. Turn the cable holders to keep the cables in place.
7. Put the camera base lid back in its original position and tighten the screws (torque
1.5 Nm).
22