AXIS Q1755-E Installation Guide
Page 9
ENGL
IS
H
Install the camera on the bracket
1. Install the camera with the bottom cover on the bracket and tighten the bracket screws.
2. Remove the gasket from one of the holes in the bottom cover, see illustration on page 7.
3. Route the cable through the hole and attach the cable gasket to the hole.
4. Connect the cables, see
Connect the cables,
on page 10.
5. Take the top cover and attach the safety wire to the tab on the bottom cover, see illustration on
page 7.
6. Install the top cover. Make sure to tighten diagonally opposite bottom cover screws a few turns
at a time until all are tight. This will help ensure that the bottom cover gasket is compressed
evenly. Do not attempt to tighten the screws completely the first time.
7. Install the cable cover and tighten the cable cover screws.
8. Loosen the sun screen adjustment screws and adjust the sunshield to the front position.
9. Loosen the bracket adjustment screw to aim the camera to the point of interest. See
Access the
video stream,
on page 16 for information on how to view the video stream.
Cable cover
Bracket screw (4x)
Cable cover screw (2x)
Network cable (route
Wall bracket
Bracket adjustment screw
through wall bracket)
Cable holes
