Axis q1615 MK II, Installation Manual, Page: 21 / 136

AXIS Q1615 Mk II Network Camera
4. Press and quickly release the function button. When the Status LED flashes green, the
Focus Assistant is enabled.
If the Status LED flashes either red or amber before you are able to adjust the lens, skip
to step 7 to exit the Focus Assistant and repeat steps 3–7. See the notes above. See
Status LED behavior for focus assistant on page 12 .
5. Gently turn the focus ring clockwise until it stops.
6. Turn the focus ring slowly counter-clockwise until the status indicator flashes green
or amber (not red).
7. To exit the Focus Assistant, press the function button again. The Focus Assistant is
switched off automatically after 15 minutes.
8. Retighten the lock screw for the focus ring.
9. If the image focus has slightly changed while tightening the zoom and focus pullers,
click Fine-tune .
10. If you want to slightly move focus position, move the Focus position slider.
Reset to factory default settings
Important
Reset to factory default should be used with caution. A reset to factory default resets all
settings, including the IP address, to the factory default values.
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button while reconnecting power. See
Product overview on
page 10 .
3. Keep the control button pressed for 15–30 seconds until the status LED indicator flashes
amber.
4. Release the control button. The process is complete when the status LED indicator turns
green. The product has been reset to the factory default settings. If no DHCP server is
available on the network, the default IP address is
192.168.0.90
.
5. Use the installation and management software tools to assign an IP address, set the
password, and access the video stream.
The installation and management software tools are available from the support pages
on
axis.com/support .
It is also possible to reset parameters to factory default through the web interface. Go to Settings
> System > Maintenance and click Default .
Further information
• For the latest version of this document, see axis.com
• The user manual is available at axis.com
21
EN