AXIS C8210 Network Audio Amplifier
Additional settings
Additional settings
Test the impedance
Test the impedance after you have connected the speaker and before you use the amplifier for the first time or when you have
changed the speaker setup, connected to the amplifier. The SPK LED will flash green when an impedance test is required. Perform the
impedance test by pressing the control button until you hear tones from the speaker.
CONTROL
CONTROL
STAT SPK
Set up direct SIP (P2P)
Use peer-to-peer when the communication is between a few user agents within the same IP network and there is no need for extra
features that a PBX-server could provide. To better understand how P2P works, see
Peer-to-peer SIP (P2PSIP) on page 11
.
For more information about setting options, see
.
1. Go to
System
>
SIP
>
SIP settings
and select
Enable SIP
.
2. To allow the device to receive incoming calls, select
Allow incoming calls
.
3. Under
Call handling
, set the timeout and duration for the call.
4. Under
Ports
, enter the port numbers.
-
SIP port
– The network port used for SIP communication. The signaling traffic through this port is non-encrypted.
The default port number is 5060. Enter a different port number if required.
-
TLS port
– The network port used for encrypted SIP communication. The signaling traffic through this port is
encrypted with Transport Layer Security (TLS). The default port number is 5061. Enter a different port number
if required.
6
