AXIS P1357-E Network Camera
Video and Audio
Audio Modes
The Axis product supports the following audio modes:
•
Full duplex –
Simultaneous two-way audio allowing the Axis product to transmit and receive audio at the same time.
There is no echo cancellation; if feedback loops appear, try moving the microphone or the speaker.
•
Half-duplex –
Audio can be transmitted to and from the Axis product but only in one direction at a time. To transmit
audio using the Live View page, use the
Talk
and
Listen
buttons, see
.
•
Simplex – Network Camera speaker only -
Audio is transmitted from a client to the Axis product and can be played by
a speaker connected to the product. To transmit audio using the Live View page, the
Talk
and
Microphone on
buttons
must both be active, see
•
Simplex – Network Camera microphone only -
Audio captured by the product microphone is transmitted from the
Axis product to one or more clients.
To set the audio mode, go to
Video & Audio > Audio Settings
and select the desired mode from the
Audio mode
drop-down list.
Audio Input
An external microphone or a line source can be connected to the Audio-in connector. Configure the audio input settings under
Video
& Audio
>
Audio Settings
.
Note
The internal microphone is used by default; the external microphone is used when connected. It is possible to disable the
internal microphone by connecting a plug to the mic input.
Note
When used in an outdoor enclosure, the internal microphone on this Axis product cannot be used.
Note
If using unbalanced Line in a mono contact must be used. Signal on tip and ground on sleeve.
Select
Microphone
to use an external microphone or
Line
to use a Line in device, e.g. an audio mixer for multiple microphones
or a microphone with a built-in amplifier, as audio source.
Select the
+30 dB microphone boost
option to amplify the signal of the external microphone connected to the Axis product.
Microphone boost option is useful when a microphone's volume is too low and you want to increase it. This option is not available
when the Line source is selected
The
Microphone power
option provides DC power for an external microphone.
Microphone power should only be used with microphones that have no battery and when using the internal microphone. This setting
should not be enabled when using a dynamic or battery powered microphone. Microphone power will not harm the microphone; if
you are uncertain, try switching it off and on.
To use a professional microphone requiring 48V phantom power, you need an external power supply and a balanced-unbalanced
converter (audio transformer) in between.
Use the
Input gain
to control the volume of the audio input. If the sound is too low, choose a higher dB value, to amplify the
sound. If the sound is too high, choose a lower dB value. The
Level
bar gives a visual representation of the audio signal level in dB
relative to the full-scale input level.
•
Green — the signal is at a good level.
•
Yellow — the signal is becoming distorted.
•
Red — the signal is distorted.
Use the
Encoding
option to select digital audio encoding format.
29