Axis 25221R3, User Manual

Page: 38 / 47

38
AXIS 262 - Troubleshooting
LED Indicators
The LED indicators on the AXIS 262 indicate the following:
Note:
Note that the indicator LEDs are tested during startup. The Status, Network and Disk LEDs show red for 1
second, and the Power LED shows amber for 1 second.
NAT traversal
Depending on your network configuration, it may be necessary to use NAT traversal to
access the AXIS 262 from a WAN. In the example shown below, NAT traversal will enable
the PC located on the WAN to access the camera and the AXIS 262, which are located on
the LAN.
In the router, port 80 can be mapped to some other port number, e.g. 8080 and port 2000
should be mapped to 2000. When this has been done, the user on the PC can access the
AXIS 262 by typing the following URL in the browser: http://212.10.10.10:8080
Note:
The camera link button may not function in the Main View when using NAT traversal. You can type the IP
address of the camera directly in Internet Explorer along with the port number that port 80 of the camera
is mapped to in the router.
Disk
Green Flashes when the hard disk is accessed.
Red Shows steady for failed reset to factory default, failed firmware upgrade, failed data-
base repair, or for a hard disk error.
To save recorded video stored on the hard disk drive, download the video to your PC and
then restart the AXIS 262 to return the hard disk to its normal state.
Network
Amber Flashes for activity on a 10 Mbps network.
Green Flashes for activity on a 100 Mbps network.
None No connection.
Status
Green Shows steady green for normal operation.
Amber Flashes during a reset to the factory default settings.
Red Flashes red in combination with red disk LED for failed reset to factory default, failed
firmware upgrade, or failed database repair. Flashes red without red disk LED to indicate
that the database is being repaired, which may take up to 30 minutes.
Power
Green Normal operation.
Amber Flashes green/amber during a firmware upgrade.