AXIOMTEK SHB130 Series, User Manual

Page: 22 / 85

SHB130 LGA1150 Full-size CPU Card
16 Board and Pin Assignments
2.4.13 FAN Connectors (FAN1, FAN2 and FAN3)
Fans are always needed for cooling down CPU and system temperature. The board has
three fan connectors. You can find fan speed option(s) at BIOS Setup Utility if either fan
is installed. For further information, see BIOS Setup Utility: Advanced\HW Monitor\PC
Health Status.
System and auxiliary fan interfaces are available through FAN1 and FAN2, see table
below.
CPU fan interface is available through FAN3, see table below.
2.4.14 Ethernet Ports (LAN1 and LAN2)
The board has two RJ-45 connectors; LAN1 (for (i217LM)) and LAN2 (for i210AT).
Ethernet connection can be established by plugging one end of the ethernet cable into
this RJ-45 connector and the other end (phone jack) to a 1000/100/10-Base-T hub.
1 2 3 4 5 6 7 8
A B
Pin Signal
1 GND
2 +12V level
3 Rotation detection
Pin Signal
1 Ground
2 +12V
3 Rotation Detection
4 Speed Control
Pin Signal
1 Tx+ (Data transmission positive)
2 Tx- (Data transmission negative)
3 Rx+ (Data reception positive)
4 RJ-1 (For 1000-Base-T only)
5 RJ-1 (For 1000-Base-T only )
6 Rx- (Data reception negative)
7 RJ-1 (For 1000-Base-T only)
8 RJ-1 (For 1000-Base-T only)
A Active LED
B Speed LED