
SHB101
LGA775 SBC User’s Manual
44
PHOENIX-AWARD BIOS Utility
Run VGABIOS if S3 Resume
When this item is set Auto, the system will run VGA BIOS if it is reaumed from the S3 state.
Power Management
This option allows you to select the type (or degree) of power saving for Doze, Standby, and
Suspend modes. The table below describes each power management mode:
Max Saving
It is maximum power savings, only available for SL CPUs. The inactivity period is 1
minute in each mode.
User Define
It sets each mode. Select time-out periods in the PM Timers section.
Min Saving
It is minimum power savings. The inactivity period is 1 hour in each mode (except the
hard drive).
Disabled
Default value
Video Off Method
This setting determines the manner in which the monitor is blanked.
V/H
SYNC+Blank
It turns OFF vertical and horizontal synchronization ports and writes blanks to the
video buffer.
DPMS
Select this option if your monitor supports the Display Power Management Signaling
(DPMS) standard of the Video Electronics Standards Association (VESA). Use the
supplied software for your video subsystem to select video power management
values.
Blank Screen
The System only writes blanks to the video buffer.
Video Off In Suspend
This item defines if the video is powered down when the system is put into suspend mode.
Suspend Type
If this item is set to the default Stop Grant, the CPU will go into Idle Mode during power saving
mode.
Suspend Mode
After the selected period of system inactivity (1 minute to 1 hour), all devices except the CPU
shut off. The default value is
“Disabled”
.
Disabled
System will never enter SUSPEND mode
1/2/4/6/8/10/
20/30/40
Min/1 Hr
Defines the continuous idle time before the system entering SUSPEND mode.
If any item defined in (J) is enabled & active, SUSPEND timer will be reloaded
HDD Power Down
If HDD activity is not detected for the length of time specified in this field, the hard disk drive
will be powered down while all other devices remain active.
Summary of Contents for SHB101 Series
