AXIOMTEK sbc84500, User Manual

Page: 36 / 60

SBC84500 User’s Manual
4.2 Installation of SVGA driver
Complete the following steps to install the SVGA driver. Follow the
procedures in the flow chart that apply to the operating system that you are
using within your SBC84500.
Important: The following windows illustrations are examples only. You
must follow the flow chart instructions and pay attention to
the instructions which then appear on your screen.
Note 1:
The CD-ROM drive is designated as "D:" throughout this chapter.
Note 2:
<Enter> means pressing the “Enter” key on the keyboard.
Note 3:
When you are using a CRT display, please make sure that your flat
panel resolution settings (in the BIOS setup) are the same as your
VGA resolution settings (in Windows). Otherwise your display may
behave strangely.
4.2.1 Installation for National MediaGX Certified
drivers for Windows 95/98.
Insert the disk into the CD-ROM drive.
1. Select "Start" then "Run".
Type the correct path for the driver (like the example below)
"D:\SBC84500\Win9X\"
Click "OK"
4.2.2 Display drivers
1. Win95, 98 drivers (VGA & Audio) in \Win9X\National Geode Win9x
Drivers 1.2
2. WinNT4.0 drivers in \NT4.0 Display Driver 5.05
Display Drivers
30