AXIOMTEK SBC8232, User Manual

Page: 15 / 50

SBC8232 386SX ISA Half-size CPU Card Family User’s Manual
Installation
9
C h a p t e r 3
Installation
This chapter describes the procedures for installing the
SBC8232V all-in-one CPU card into your system.
The following is a list of typical peripherals required to build a
minimum system:
!
Power supply and passive backplane (optional)
!
IBM PC/AT keyboard
!
Display monitor
!
Floppy or hard disk with MS-DOS or Flash Disk
emulator
3.1 Installing SIMMs
You can install from 1MB up to 32MB memory onboard using 1,
4 or 16MB 72-pin single-side fast-page or EDO SIMMs.
1. Ensure that all power supplies to the system are
switched Off.
2. Insert the first SIMM edge connector at a slight
angle into the socket of SIMM 1 close to the center
of the board. Note that the SIMMs are keyed and
will only go in one way.
3. Push the SIMM back into the connector carefully
until it snaps into place.
4. Check to make sure the SIMM is inserted securely.
5. Repeat Steps 2-4 for remaining SIMM in SIMM 2. Or,
you can install one SIMM only on the board.