AXIOMTEK NA-814, Hardware Installation Manual, Page: 24 / 58

NA-814 Hardware Installation Guide
Installation Procedures 18
PS, The above mention pictures for CPU deployment instruction was
adopted by Intel internet web
Put the copper heat sink on the upper of CPU. The fin of heat sink should
be vertical run from I/O shield. To use the four screws to clamp the heat
sink.
2.4.3 Installing a memory module (DIMM)
The main board can supports two 184-pin DDR socket for a maximum
total memory up to 2GB
None-ECC unbuffer Memory
.
CPU FSB DDR Type DDR Frequency
800MHz PC3200/PC2700/PC2100 400/333*/266MHz
533MHz PC2700/PC2100 333/266MHz
*Because limited of chipset, when using FSB800Mhz CPU, PC2700
DDR (333Mhz) only support 320Mhz.
Attention:
¾
When you handle electrostatic discharge-sensitive (ESDs), take
precautions to avoid damage from static electricity.
2.4.4 Installing a DMA33/66/100 hard drive
To accommodate the fast transfer rate of Ultra DMA33/66/100, a cable
(with 40 pin connectors on both ends) is necessary when installing Ultra
DMA33/66/100 drives. The NA-814 , on this aspect, can support IDE hard
drive and DOM (Disk on Module) deployment. It is through the IDE
Connector (CN18)
Put the HDD into a tray. Plug the IDE round cable for hard drive and main
board both side. Then put the tray to the right-back site of the system