AXIOMTEK NA-401, Hardware Installation Manual

Page: 23 / 68

NA-401 Hardware Installation Guide
Installation Procedures 17
Figure 2.10; Put the copper heat sink on the upper of CPU. The fin of
heat sink should be vertical run from I/O shield. To use the four
screws to clamp the heat sink.
Figure 2.11, Then to use the FAN dock to cover the heat sink with
CPU. Make it to be better efficiency from thermal point of view.
2.2.3 Installing a memory module (DIMM)
The main board can supports two 184-pin DDR socket for a
maximum total memory up to 2GB
None-ECC unbuffer Memory
.
The Intel 875 can support Single- and Dual-Channel Operation
1. In single-channel operation DIMM2 is disabled. Only DIMM1 need
be added.