NA-0043 Hardware Installation Guide
12 Installation
Procedures
2.2 Setting
up
the appliance
This section provides the information about the initial installation to
setup the
NA-0043
2.2.1 Removing and Replacing the Top Cover
To gain access into the internal components of the
NA-0043
, you
must follow the instructions given below to remove the top cover.
Please release the screws of lower case and left with right side first,
X
Main Board
2.2.2 Installing a memory module (DIMM)
The
main board
can supports one SODIMM DDR socket for a
maximum total memory up to 1GB
None-ECC unbuffer Memory
.
The device can support Single-Channel Operation
1. In single-channel operation DIMM2 is disabled. Only DIMM1 need
be added.
Attention:
X
When you handle electrostatic discharge-sensitive
(ESDs), take precautions to avoid damage from static
electricity.
Y
The memory can support DDR266.
2.2.3 Installing a ATA66/100/133 hard drive
To accommodate the fast transfer rate of Ultra ATA/66/100/133, a
cable (with 44 pin connectors on both ends) is necessary when
