Machine Vision MIRU130 Board
30
Operating
4.1.2
Trigger Input/Output
The MIRU130’s trigger input supports de-bounce filter function to help filter out
environmental noise that can mix with normal encoder signals and affect the accuracy of
the pulse count. The de-bounce filter defines the interval width for high/low signals.
Signals with interval width less than the defined value will be filtered out.
Below is a diagram illustrating the case of filter timer set with a duration time of 2
millisecond:
Trigger input
signal
Filtered
signal
<2ms
2ms
<2ms
2ms
<2ms
Trigger Output CH 0~1 provides the following parameters to configure:
Trigger source
The user can select any of the following items as a triggering condition that prompts
the MIRU130 to generate a trigger output: Trigger Input CH 0~3, Encoder Phase Z,
Encoder Check Pointer CH0~2.
Note:
One trigger source can be set to activate multiple trigger outputs.
Delay time function
The user can set the delay time that the MIRU130 waits before it sends a trigger
output.
Duration time
The user can adjust pulse width for the output signal.
Definitions of delay time and duration time are illustrated below:
Trigger Source
Trigger Output
Delay Time
Duration
Inverter
Trigger source mode can be set as rising trigger or falling trigger.
Summary of Contents for MIRU130
