AXIOMTEK GOT318W-521-PCT, User Manual

Page: 27 / 67

GOT318W-521-PCT User’s Manual
Hardware and Installation 19
2.5 Hardware Installation
2.5.1 Installing an HDD
The GOT318W-521-PCT provides a convenient swappable Hard Disk Driver (HDD) bracket for
users to install a 2.5” (supports 7mm & 9.5mm) wide temperature SATA HDD. Please follow the
steps below to install the HDD:
Step 1 Refer to Section 2.1 to open the back cover
Step 2 Unfasten the bracket screw and then slide the HDD bracket out of the system
unit. (as shown in Figure 2-13)
Figure 2-13: Remove the HDD tray
Step 3
Insert the 2.5” HDD into the bracket and fasten the four screws on the bottom
side of the bracket to hold the HDD firmly to the bracket.
Step 4 Slide the bracket back into the system unit.
Step 5 Plug the “SATA + Power” connector into the HDD.
Step 6 Fasten the bracket screw to complete installation.
Figure 2-14: Fasten an HDD to the bracket and plug in the “SATA + Power” connector