AXIOMTEK GOT3187WL-834-PCT, Owner'S Manual

Page: 16 / 54

GOT3187WL-834-PCT
User’s Manual
10 Hardware and Installation
2.3 Jumper and Switch Setting
Jumper is a small component consisting of jumper clip and jumper pins. Install jumper clip on 2
jumper pins to close. And remove jumper clip from 2 jumper pins to open. The following
illustration shows how to set up jumper.
Before applying power to GOT3187WL-834-PCT, please make sure all of the jumpers and
switch are in factory default position. Below you can find a summary table and onboard default
settings.
Jumper Description Setting
JP7
Auto Power On
Default: Disable
2-3 close
JP8
Restore BIOS Optimal Defaults (Clear CMOS)
Default: Normal Operation
1-2 close
JP6
Switches mSATA or
CFast
TM
setting.
Default: 1-2 = CFast™, 2-3 = mSATA
1-2 close
2.3.1 Auto Power On (JP7)
If JP7 is enabled for power input, the system will be automatically power on without pressing
soft power button. If JP7 is disabled for power input, it is necessary to manually press soft
power button to power on the system.
2.3.2 Restore BIOS Optimal Defaults (JP8)
Put jumper clip to pin 2-3 for a few seconds then move it back to pin 1-2. Doing this procedure
can restore BIOS optimal defaults.
Function Setting
Enable auto power on 1-2 close
Disable auto power on (Default) 2-3 close
Function Setting
Normal operation (Default) 1-2 close
Restore BIOS optimal defaults 2-3 close