AXIOMTEK DSB320-842 Series, User Manual

Page: 38 / 75

DSB320-842 User’s Manual
30
Jumper Settings & Connector
3.2.1 Audio Output Selection (JP2)
Use this jumper to select line out or speaker out as source of audio output on audio connector.
When speaker out is used, it delivers 1W/channel continuous at 8
Ω loads .there is no speaker
out function available.
3.2.2 Restore BIOS Optimal Defaults (JP4)
Put jumper clip to pin 2-3 for a few seconds then move it back to pin 1-2. Doing this procedure
can restore BIOS optimal defaults.
3.2.3 Auto Power On (JP10)
If JP10 is enabled for AC power input, the system will be automatically power on without
pressing soft power button. If JP10 is disabled for AC power input, it is necessary to manually
press soft power button to power on the system.
Note
This function is similar to the feature of power on after power failure, which is
controlled by hardware circuitry instead of BIOS.
Function Setting
Line out 1-3, 2-4 close
Function Setting
Normal (Default) 1-2 close
Restore BIOS optimal defaults 2-3 close
Function Setting
Disable auto power on (Default) 1-2 close
Enable auto power on 2-3 close