CEB94011 COM Express
TM
Type 6 Development Baseboard
10
Board and Pin Assignments
2.4 Jumper
Settings
Jumper is a small component consisting of jumper clip and jumper pins. Install jumper clip on 2
jumper pins to close. And remove jumper clip from 2 jumper pins to open. Below illustration
shows how to set up jumper.
Properly configure jumper settings on the CEB94011 to meet your application purpose. Below
you can find a summary table of all jumpers and onboard default settings.
Note
Once the default jumper setting needs to be changed, please do it under power-off
condition.
Jumper
Description
Setting
JP1
Auto Power On
Default: Disable
2-3 Close
JP5
LVDS Voltage Selection
Default: +3.3V
1-2 Close
JP6
LVDS/eDP Function Selection
Default: LVDS
1-2 Close
JP7
Boot BIOS Selection
Default: Boot from Module BIOS
1-3, 2-4 Close
JP9
Power Input Mode Selection
Default: ATX/AT mode
2-3 Close
JP11
1-2 Close
JP10
Restore BIOS Optimal Defaults
Default: Normal Operation
1-2 Close
JP12
DIO/SD Card Function Selection
Default: DIO
1-2 Close
JP13
Thermal Trip Indicator
Default: Disable LED
1-2 Close
JP14
LVDS Brightness Control Mode Setting
Default: PWM mode
1-2 Close
