WARNING! CAREFULLY READ THE FOLLOWING INSTRUCTIONS AND CONDITION OF USE:
• SW2100A is NOT designed to be suspended, use it in ground stack only.
• This loudspeaker is designed exclusively for Professional audio applications. The product must be installed by qualified personal only.
• Proel strongly recommends that this loudspeaker cabinet be suspended taking into consideration all current National, Federal, State and
Local regulations. Please contact the manufacturer for further information.
• Proel do not accept any liability for damage caused to third parties due to improper installation, lack of maintenance, tampering or
improper use of this product, including disregard of acceptable and applicable safety standards.
• During assembly pay attention to the possible risk of crushing. Wear suitable protective clothing. Observe all instructions given on the
rigging components and the loudspeaker cabinets. When chain hoists are in operation ensure that there is nobody directly underneath or
in the vicinity of the load. Do not under any circumstances climb on the array.
BASIC INSTALLATION INSTRUCTIONS
Stacked installation of AX12C using SW2100A subwoofer as base
WARNING!
• The ground where the SW2100A is placed needs to be absolutely stable and compact.
• Adjust the feet so to lie the SW2100A perfectly horizontal to ground. Use a spirit level to obtain the best result.
• Always secure ground stacked setups against movement and possible tipping over.
• A maximum of 2 x AX12C speakers are allowed to be installed over a SW2100A serving as ground support.
Other installation examples are explained in the AX12C user manual.
Pin locking and splay angles set up
The figure below shows how to insert correctly the locking pin and how to set up the splay angle between loudspeakers.
LOCKING PIN INSERTION
press and
insert
SW2100A-AX12C
and
AX12C-AX12C
locking pin
release
and lock
When connecting two speakers
together or one speaker to an
installation accessory, insert
the pin in this hole first,
also use it to rest the pin when unused.
Use these holes for the splay angle:
0°
as no splay.
2°
as normal splay angle to obtain
a curved vertical array.
4°
as splay angle to aim the first speaker
downward (stacked only).
AX12C SPLAY ANGLE SET UP
