6
Maintenance
1. Before attempting to service or disassemble any component, make sure that the unit is
disconnected from the power source.
2. Remove the drain hose from the inlet hole. Uninstall the check valve from the main plate (see
figure 6 below). Disassemble the outlet piping from the check valve. Clean the check valve and
be sure that the ball inside of check valve moves freely.
3. Remove the steel plate and plastic cover from the tank.
4. Be sure the floats move freely. Clean as necessary.
5. Remove neutralization media and clean the reservoir with warm water and mild soap. Rinse
with water. Replace LipHter
+
media in tank.
6. Check the inlet and outlet piping. Clean as necessary. Be sure there are no kinks in the line
that would inhibit flow.
7. After servicing, assemble the unit in the reverse order.
8. In case of a long-term break, remove water from the outlet piping and reservoir.
9. Monitor the cleanliness, level of the neutralization media, and pH level in the tank monthly. Remove
any precipitate coating or debris found to prevent blockages. The pH can be checked after the
condensate has exited the tank or by removing the lid and taking a sample from the pump out chamber.
Use a suitable pH test strip paper or an electronic pH meter for precise measurement. The neutralizing
media should be replaced when the pH level drops below the minimum level of the local water
authority, or after one year, whichever comes first. For replacement media contact your local
Axiom distributor or visit www.axiomind.com for more information.
To remove
→
Turn the check valve 90˚ counter-clockwise and lift
the check valve out of the hole
For Installation
→
Put the check valve into the hole and turn 90˚
clockwise
Figure 6
