D E M O 9 S 1 2 X D T 5 1 2
J U L Y 1 8 , 2 0 0 8
6
♦
USB_SPEED
♦
Connectors
♦
Two 40-pin, pass-thru type, MCU I/O Connectors, providing access to most MCU IO signals
♦
2.0mm barrel connector power input
♦
USB Type-B connector
♦
6-pin BDM interface connector (not installed)
♦
DB9 COM connector
♦
2 4-pos LIN connectors
♦
3-pos CAN connector
♦
Supplied with LIN Cable, USB Cable, Documentation (CD), and Manual
Specifications:
Module Size 4.0” x 3.1”
Power Input: +6VDC to +18VDC
NOTE:
LIN functionality supported when powered from PWR connector only
REFERENCES
Reference documents are provided on the support CD in Acrobat Reader format.
DEMO9S12XDT512_UG_A.pdf
DEMO9S12XDT512 User Guide (this document)
DEMO9S12XDT512QSG.pdf
DEMO9S12XDT512 Quick Start Guide
DEMO9S12XDT512 _SCH_D.pdf
DEMO9S12XDT512 Schematic Rev. D
9S12XDP512V2_ZIP.zip
DEMO9S12XDT512 Device User Guide
AN2546.pdf
S12X Load RAM and Execute (LRAE) Program Appli-
cation Note
AN2615.pdf
HCS12 and S12X Family Compatibility
AN2685.pdf
How to Configure and Use the XGATE on S12X De-
vices
AN2708.pdf
An Introduction to the External Bus Interface on the
HCS12X
GETTING STARTED
To get started quickly, please refer to the DEMO9S12XDT512 Quick Start Guide. This quick
start will show the user how to connect the board to the PC, run a LED test program, install the
correct version of CodeWarrior Development Studio, and load an Analog to Digital (ATD) test
program using CodeWarrior.
OPERATING MODES
The DEMO9S12XDT512 board operates in two operating modes: Run Mode, or Debug Mode.
Run Mode allows user application operation from Power-On or Reset. Debug Mode supports
the development and debug of applications. See the related sections below for quickly starting
the board in the desired operation mode.
The board has been preloaded with a demonstration program. The demo program operates in
