3
GETTING STARTED
The Axiom CME11E9-EVBU single board computer is a fully assembled, fully functional
development system for the Motorola 68HC11 Micro controllers, complete with wall plug
power supply and serial cable. Follow the steps in this section to get started quickly and
verify everything is working correctly.
Support software for this development board is provided for both DOS, Windows 3.1 as well
as 32-bit Windows 95 and greater operating systems.
Installing the Software
1. Insert the Axiom 68HC11 support CD in your PC. If the setup program does not start
automatically, run the file called "SETUP.EXE" on the CD.
2. Follow the instructions on screen to install the AxIDE software onto your hard drive then
run the AxIDE program.
3. Select the PC serial port you're using to connect to the board.
4. Select your development board " CME11E9-EVBU" from the drop-down menu bar just
below the main menu.
Board Startup
Follow these steps to connect and power on the board. This assumes you're using the
provided utility program (described in the previous section) or a similar communications
terminal program on your PC, and that all the jumpers are in their default (from the
manufacturer) positions. If you're using a different terminal program than the one provided,
set it's parameters to 9600 baud, N,8,1.
1. Connect one end of the supplied 9-pin serial cable to a free COM port on your PC.
Connect the other end of the cable to the COM port on the CME11E9 board.
2. Apply power to the board by plugging in the wall plug power supply that came with the
system.
3. If everything is working properly, you should see a Buffalo Monitor prompt similar to that
below in the Terminal window. Press the ENTER key and you should see a prompt
which is the > character.
BUFFALO 3.4 (ext) - Bit User Fast Friendly Aid to Logical
Operation
>_
4. Your board is now ready to use!
