LIMITED WARRANTY
Proel warrants all materials, workmanship and proper opera on of this product for a period of two years from the original date of purchase. If any defects are found
in the materials or workmanship or if the product fails to func on properly during the applicable warranty period, the owner should inform about these defects the
dealer or the distributor, providing receipt or invoice of date of purchase and defect detailed descrip on. This warranty does not extend to damage resul ng from
improper installa on, misuse, neglect or abuse. Proel S.p.A. will verify damage on returned units, and when the unit has been properly used and warranty is s ll
valid, then the unit will be replaced or repaired. Proel S.p.A. is not responsible for any “direct damage” or “indirect damage” caused by product defec veness.
• This unit package has been submi ed to ISTA 1A integrity tests. We suggest you control the unit condi ons immediately a er unpacking it.
• If any damage is found, immediately advise the dealer. Keep all unit packaging parts to allow inspec on.
• Proel is not responsible for any damage that occurs during shipment.
• Products are sold “delivered ex warehouse” and shipment is at charge and risk of the buyer.
• Possible damages to unit should be immediately no
fi
ed to forwarder. Each complaint for package tampered with should be done within eight days from product
receipt.
SAFETY INSTRUCTIONS
– To reduce the risk, close supervision is necessary when the product is used near children.
– Protect the apparatus from atmospheric agents and keep it away from water, rain and high humidity places.
– This product should be site away from heat sources such as radiators, lamps and any other device that generate heat.
– This product should be located so that its loca on or posi on does not interfere with its proper ven la on and hea ng dissipa on.
– Care should be taken so that objects and liquids do not go inside the product.
– The product should be connected to a power supply mains line only of the type described on the opera ng instruc ons or as marked on the product. Connect the
apparatus to a power supply using only power cord included making always sure it is in good condi ons.
– WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily operable.
– Do not cancel the safety feature assured by means of a polarized line plug (one blade wider than the other) or with a earth connec on.
– Make sure that power supply mains line has a proper earth connec on.
– Power supply cord should be unplugged from the outlet during strong thunderstorm or when le unused for a long period of me.
CE CONFORMITY
Proel products comply with direc ve 2004/108/EC (EMC), as stated in EN 55103-1 and EN 55103-2 standards and with direc ve 2006/95/CE (LVD), as stated in EN
60065 standard.
PROEL S.p.A. (World Headquarter) - Via alla Ruenia 37/43 - 64027 Sant’Omero (Te) - ITALY
Tel: +39 0861 81241 Fax: +39 0861 887862 www.axiomproaudio.com
OUT:
in this page you can see the level of the output signals and the gain reduc on if the
limiters are ac vated. You can also trim (±6 dB) the output signals in order to adjust the balance
of LF, MF and HF ranges.
WARNING!
The limiter se ng of PC260 and 2065 preset is set for the use of 32 dB
fi
xed gain power
ampli
fi
ers: contact PROEL if you need a di
ff
erent se ng.
The delays are set for the op mal alignment of a standard
fl
own con
fi
gura on with the
ver cal array on top of the subwoofers.
If needed, the delay of the subwoofers (LOW-L and LOW-R) can be adjusted in rela on
to the MID-HIGH outputs for the op mal alignment when the system is installed in a
di
ff
erent posi on.
WARNING!
The DELAY di
ff
erence between MID and HIGH outputs must always be 93 mm (HIGH a er
MID). If you modify the MID delay to align the tops with the subs, remember always to
set the HIGH delay accordingly (+93 mm).
GEQ:
this is the graphic equalizer on the processor inputs to be used for equalizing the whole
system. It can be used for adjus ng the system’s response or for
fi
xing par cular frequency
problems in the environment where the system is installed. The AX2065P preset has been
prepared in order to obtain the best performance from the system, so we suggest to avoid
extreme use of the GEQ.
PEQ:
this is a full parametric 5-band equalizer on the processor’s inputs. Each
fi
lters can be set
also as shelving, notch, allpass, high-pass and lo-pass, so this equalizer can be used to op mize
the system response according to the environment characteris cs, including temperature,
humidity and absorp on due to the audience.
DEQ:
in the 2065 presets the 3-band dynamic equalizer is used to op mize the system’s
response so we suggest to do not change its parameters and use it as it is already set.
