Field of application:
The devices are only suitable for distributing radio and television signals inside
the house! If a device is used for other purposes, no warranty is given!
Connectors, switches:
1 SAT inputs for LNB:
LV, LH, HV and HH for Quattro LNB system 1
V and H for Wideband LNB system 1
V and H for Wideband LNB system 2
LV, LH, HV und HH für Quattro-LNB-System 2
V and H for Wideband LNB system 3
V and H for Wideband LNB system 4
2 TERR input
3 Equipotential bonding connection
4 Subscriber ports
5 DC connector for power supply SZU 99-06
6 SAT cascade outputs
7 TERR cascade output
8 Mounting angles
9 Wideband/Quattro switch
10 One rotary switch for SAT positions for each subscriber port
(relevant to EN 50494)
11 One CSS/Legacy switch for each subscriber port
3
5
8
1
2
4
6
7
9
4
8
8
8
4
4
10
11
RF installation:
Connect the SAT inputs (1) of the multiswitch to the LNBs of your SAT
reception antenna. Connect the output signals of a terrestrial amplifier or a
CATV amplifier to the terrestrial input (2).
Connect the subscriber outputs (4) of the multiswitch to the antenna
sockets. Use highly shielded coaxial cables with F connectors. Suitable
cables and connectors can be found in the current AXING catalogue or
under www.axing.com.
If you don´t use cascade units to expand the multiswitch, terminate
the outputs (6 + 7) on the lower side with termination resistors
CFA 11-00
(not included in delivery).
Equipotential bonding and mounting:
To avoid dangerous power surges (e.g. risk of fire and danger of life) the device
must be connected to the equipotential bonding according to EN 60728-11.
Use the equipotential bonding connection at the device (3).
To connect the outer conductor of the coaxial cable to the equipotential
bonding, use e.g. QEW earthing angles at the inputs and outputs of the
device.
Use appropriate mounting screws for the mounting angles of the device (8).
Wideband-LNB:
The single-cable multiswitches can be used with wideband LNB with an
oscillator frequency of 10.4 GHz.
Slide the sliding switch (9) to W = Wideband.
Connect the four wideband LNBs to ports V and H.
Terminal devices according to EN 50494 can only receive 2 SAT
positions.
Use the rotary switch (10) on the subscriber output to select which two
SAT positions should be received.
For terminal devices with EN 50607 the rotary switch position is
irrelevant. These devices receive all four SAT positions.
Cascading:
Up to three single cable multiswitches can be connected to one cascade.
Connect the outputs of the single cable multiswitch with the inputs of
the next single cable multiswitch units.
Use F/F Quickfix adapters CFA 4-01 (not included in delivery).
Terminate the outputs of the last single cable multiswitch with resistors
CFA 11-00 (not included in delivery).
Legacy mode:
Each output can be switched to legacy mode separately (11). The output then behaves as a normal multiswitch output. This allows to connect receivers
which don´t support CSS/SCR.
Legacy mode can not be used with wideband LNBs!
Power supply:
The single cable multiswitch is fed by the connected
receivers.
The LNBs are fed via the SAT IF lines e. g.:
9
via a head amplifier
9
as pictured, via an ext. power supply SZU 99-06 (not
included)
