2020-03-19 | Technical improvements, changes in design, printing- and other errors expected.
3
Safety instructions:
∂
The installation of the device and repair work on the device must be carried out only by a professional
in accordance with the applicable VDE directives. In case of incorrect installation, no liability is
assumed.
∂
Never open the device. There are no parts to be maintained by the user inside the device, however,
lethal voltages are present. This also applies to cleaning the device or working on the connections.
∂
Use only the mains cable enclosed to the device. Never replace any parts or make any modifications to
the mains cable. Otherwise, there is a risk of death.
∂
If you intend not to use the device for a longer period of time, we recommend you to completely
disconnect the device from the mains for safety reasons and for saving energy by pulling out the mains
plug.
∂
Let the device adjust to the room temperature before commissioning, in particular if condensation is
present on the device, or if it was exposed to large temperature fluctuations.
∂
The device must be operated only in moderate climate.
∂
The device must be operated only in dry rooms. In damp rooms or outdoors, there is a risk of short-
circuits (attention: risk of fire) or electrical shocks (attention: risk of death).
∂
The device shall not be exposed to dripping or splashing. Do not place objects filled with liquids such
as vases on the device.
∂
The mains plug is used as a disconnecting device from the mains voltage both during service and in
case of danger and must therefore be reachable and usable at all times. After connection to the mains,
the device is in operation.
∂
Select the mounting or installation location such that children cannot play near the device and its
connections without supervision. The mounting or installation location must allow a safe installation of
all connected cables. Power supply cables and supply cables must not be damaged or squeezed by any
objects.
∂
Operate the device only on a flat, firm surface and protect it against unintentional movements.
∂
Never expose the device to direct solar irradiation and avoid direct vicinity of heat sources (e.g.
heaters, other electrical appliances, fireplace, etc.). It must be always ensured that devices with cooling
elements or ventilation slots are not covered or obstructed.
∂
Ensure generous air circulation around the device. This will prevent possible damage to device and risk
of fire due to overheating. It must be always ensured that cables are not located near heat sources
(e.g. heaters, other electrical appliances, fireplace, etc.). The unit must be wall mounted with at least 5
cm clearance along the 4 sides. For 19-inch rack mounting, there must be at least 5 cm clearance in
front of and behind the unit.
∂
In particular, the warranty and liability shall be excluded for the consequences of incorrect use, in case
of incorrect modifications or repair work carried out by the customer. Use the device only as described
in the operating instructions and in particular according to the state-of-the-art.
The antenna system must be installed and grounded according to the current DIN EN 60728-11 standard.
Herewith AXING AG declares that the marked products comply with the valid guidelines.
WEEE Nr. DE26869279 | Electrical and electronic components must not be disposed of as
residual waste, it must be disposed of separately.
