EN
5
INSTALL THE TRANSMITTER BATTERIES
1. Press the battery compartment latch and rotate the batter cover to open.
2. Install 4 AA alkaline batteries (or Ni-Cd or Ni-MH), verifying correct polarity.
3. Close the battery cover until it latches.
CAUTION:
NEVER remove the transmitter batteries while the
vehicle is powered ON. Loss of vehicle control, damage, or injury
may occur.
CAUTION:
If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries may
cause the batteries to burst, resulting in injury or property damage.
CAUTION:
Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to state and local laws.
TRANSMITTER AND RECEIVER BINDING
The BIND function allows you to bind the transmitter and receiver. When new, it is necessary
to pair the transmitter and receiver to prevent interference from radio controllers operated by
other users. This operation is referred to as “binding.” Once the binding process is complete,
the setting is remembered even when the transmitter and receiver are turned OFF. This
procedure generally needs to be done once.
Before starting the binding process, connect the switch harness, servos, and the receiver
battery to your 3-Channel receiver. Verify both the transmitter and receiver are OFF.
1. Press the Bind button and power on the transmitter. The transmitter LED will fl ash.
2. Power on the receiver. The receiver LED will fl ash.
3. When the LED changes to solid, binding is complete.
When the binding process is successful, the receiver BIND LED will stay solid red when both the transmitter and
receiver are turned ON. If the receiver BIND LED is fl ashing rapidly or not illuminated at all, the transmitter and receiver
are not paired. Turn both the transmitter and receiver OFF, then repeat the binding process.
Under some circumstances, the receiver may not operate after the transmitter and receiver are turned ON. If this occurs,
repeat the binding process.
NOTICE:
Do not attempt to bind the transmitter and receiver if there are other compatible transmitters in the bind
mode within 400 feet. Doing so may result in unexpected binding.
