Axeon Water Technologies CT-4000, User Manual, Page: 8 / 54

8
ENGF-107 REV. A 01/11 © 2011 AXEON Water Technologies
NOTE: IT’S RECOMMENDED THAT A LICENSED ELECTRICIAN WIRE YOUR
SYSTEM IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODES
(NEC).
WARNING: TO REDUCE THE RISK OF ELECTRICAL SHOCK, THE
INCOMING POWER SUPPLY MUST INCLUDE A PROTECTIVE EARTH GROUND.
CT-Series systems are typically controlled with a liquid level switch in a storage tank.
The liquid level switch turns the system on when the water level in the tank drops, and
off when the tank is full. Liquid level switches can be obtained by your local dealer or
distributor. If a liquid level switch is to be used, install it at this time.
PRE-FILTRATION
CT-Series systems are supplied with a 5 micron sediment filter, 10 micron carbon block
and a 1 micron sediment filter. Change the cartridge once a month or when a 10-15 psi
differential exists between the two pre-filters. Ask your local dealer or distributor about
Pre-Filtration systems, if required.
NOTE: THE SYSTEM MUST BE OPERATED ON FILTERED WATER ONLY.
PUMP
The pump type used on the CT-Series systems is multi-stage centrifugal carbon steel
pumps. These pumps are also available as an option in stainless steel.
Follow these guidelines to ensure proper operation of the pump:
•
The pump must NEVER be run dry. Operating the pump without sufficient feed
water will damage the pump.
•
ALWAYS feed the pump with filtered water. The pump is susceptible to damage
from sediment and debris.