J
5x
5x
Assembly manual
Assembly preparation
4
Measure the height (outer frame dimension) of the roof
window.
5
Connect the two casing plates A
7
and
8
using connection
support SW
9
if the height of the roof window is less than
85 cm. Use connection support LW
10
if the height of the
roof window is greater than 85 cm (figure
E
).
Always use casing plates with A mark for centre-pivot
roof windows
- Connection support SW for window height 70 - 85 cm
- Connection support LW for window height 85 - 160 cm
or for situations in which the centre-pivot axis is higher
up (off centre)
6
Place the casing plate set on top of the metal mounting
plate
11
(figure
F
).
7
Mark the middle of the window on the window casing.
8
Close the roof window using the top control bar.
9
Position the casing plate set at the centre of the roof
window. Make sure that the large casing plate A is placed
flush against the frame and the small casing plate A is
placed flush against the roof window (they must be at a 90°
angle to one another, figure
G
).
10
Mark off the four holes for the metal mounting plate
(figure
H
).
11
Pre-drill the holes (Ø 2 mm) and fix the metal mounting plate
in place with screws
14
(4,2 x 32 mm, figure
I
).
When using a wireless drill, you must make the last
few tightening revolutions by hand
Assembly
12
Re-position the casing plate set. Pre-drill the 5 holes for the
large casing plate A (Ø 2 mm). Fix the casing plate in place
using screws
13
(4,0 x 40 mm, figure
J
).
13
Pre-drill the the countersunk hole for the small casing plate
A (Ø 2 mm). Fix the small casing plate A in place with
screw
13
(4,0 x 40 mm, figure
K
).
The configuration time is 20 seconds. The LED light
will switch off once this time passes. If you want to
configure the remote control or another remote
control, you must briefly remove the batteries and
then re-insert them. Then repeat step 2.
- A remote control can be configured to an unlimited
number of window units.
- A window unit can be configured to maximum 8
remote controls.
3
Press the Open button again and allow the chain to fully exit
the closing unit.
The closing unit is now ready for assembly (figure
D
).
AXA Remote 2.0
37-341 (11-13)
EMC 2004/108/EC
2
Remote-controlled window opener
for centre-pivot roof windows
E
G
90°
K
1x
1x
F
H
I
4x
