Place Scale on a horizontal flat surface.
1. Press [ ] key.
2. Wait until "0.0” is displayed.
3. Put the object(s) on the weighing platform.
4. Using the [MODE] key, you can switch between the
weighing units.
II. TARE WEIGHING
1. Turn on scale as described above.
2. Place the "tare item" on the platform.
3. Press [ ] and wait until "0.0" is displayed.
4. Add the "net-weight-item".
III. CALIBRATION
Calibration is NOT required before first use. Only
calibrate if scale is not weighing properly.
**Make sure you use a 500g calibration weight for your
scale or the calibration will not be accurate**
Calibration Procedures
1. Press [
] key to turn the scale on.
2. Press and hold the [
] key until the display shows”CAL”.
Release the key now.
3. The display will flash “0.0”. Press the [
] key again.
4. The display will flash “500.0”. Place your 500g calibration
weight on the scale.
5. Press [
] again. The display should read “PASS”.
You can now turn off your scale.
Please check the availability of weights with your scale
supplier.