8
INSTALLATION
WARNING
Electrical Shock Hazard
Disconnect power before servicing
• In case of a direct connection to the house wiring is preferred, do the following:
• Disconnect the power.
• Cut off the plug from the power cord.
• Connect the wires from the power cord to the wires from the house wiring using UL listed wire connectors.
• Store the excess wires in the wiring box.
• Reconnect the power.
Installing the Baffle Filters
• Peel off the protective film from the baffle filters if there's any:
• Soak the Baffle Filters into hot waters or use heated air from a hair dryer to soften the films.
• Peel off the films from the corner.
• Align the baffle filters with the Hood Unit and install them from left to right.
Note
Optional Aluminum Mesh Filters are available for purchase.
Optional Ductless Configuration
• Remove the grease filters from the bottom of the hood.
• Remove the Fan Wheel Grille or the old Charcoal Filter from the Blower.
• Position the Charcoal Filter onto the side of the Blower, aligning the
mounting screws, turn until it locks. Re-install the grease filters.
(
Figure 4
and
Figure 5
)
Note
• For ductless installation, make sure there are vent openings on the top of the
wood hood in order to circulate the air in the kitchen.
• Charcoal Filters must be replaced after 120 hours of use (or approximately
every 2 to 3 months based on the average of 1 to 2 hours of daily cooking
time.).
Completing the Installation
Turn power ON in the control panel. Check all lights and fan operations.
Figure 5
Figure 4
