DC-1023
- 10 -
8/5/2010
Your best option for Proximity Access Control
4.2 INSTALLATION
STEPS
1. Prepare the single-gang electrical wiring box for Reader mounting. Observe ADA
requirements.
2. If double-gang electrical box is used, drill through the four blind mounting holes on
the four corners of the Reader.
3. Guide the open end of the Panel’s control cable through the access hole on the
electrical junction box. Secure the cable by tightening the cable clamp.
4. Remove the Snap-On cover of the Reader (item b of the parts list)
5. Connect the Reader and the Panel together according to Figure 1 for Wiegand
format, Figure 2 for RS-232 format and Figure 3 for Wiegand/RS-232 format.
6. Setup for the RS-232 is: 9600 baud rate, 1 start bit, 1 stop bit, no parity.
4.3 VERIFICATION
1. Power up the Panel, the LED on the Reader should show RED.
2. Place a “good” card in front of the Reader. The reader will give out “ONE”
audible BEEP and the LED will change from RED to AMBER momentarily and
then flashing between RED & GREEN. The Reader will stay flashing until the
card is removed from the reader. You can repeat this action by placing the
card in front of the reader after the LED turned RED. If the Panel did not right
it must be powered off/on to re initialize.
4.4 MOUNTING
1. Connect the remaining wires to the Panel.
2. Mount the Reader securely to the electrical junction box with #6-32x1
machine screw,
(Item c on Parts List.)
3. Install the Snap-On cover.
5 Warranty
AWID’s products are warranted to the original purchaser to be free of defects in material
and workmanship for the life of the product. Any tampering or modification to the
product will void this product warranty. AWID does not warrant any product as to its
merchantability or suitability of use. AWID's sole and complete responsibility under this
warranty is expressly limited to repair or replacement of the warranted product.
6
Return Material Authorization (RMA)
AWID monitors and tracks the life cycle performance of our product through our RMA
system. All customers must obtain a RMA number from AWID Customer Service
Department prior to returning the merchandise. After the customer provides AWID
Customer Service Department with the serial number and a description of the returning
item, a RMA number will be issued.
This RMA number must be clearly marked on
the outside of the returned package and noted on the paperwork attached to the
returned merchandise.
