•
Remove the electric cover (
4
) fixed with screws (
3
).
Applicable to the H version: A sensor is attached to the electric cover. Remove the cover carefully so as not to damage the wiring harness connecting the sensor to
the controller.
•
Route the power cord in double insulation through the rubber grommet (
10
). Insert a sufficient length of the cord so that the wires can be connected to the power
terminals.
Before mounting the fan: remove all foreign objects from its inside; check manually that the fan rotor moves freely; check that there is room for opening the
non-return valve baffle (9) located at the outlet of the bathroom extractor fan;
It is recommended to connect the fan to the duct using a flexible pipe connection!
•
Place the fan housing (
8
) and the mounting pins in the previously drilled holes.
ATTENTION: The fan must be mounted so that the electrical compartment is at the top.
•
Mount the fan to the substructure by driving the screws into mounting pins through the mounting holes (
11
).
•
Remove the outer insulation from the power cord and remove the 4 mm of insulation from the wires.
•
Arrange the power cord and connect according to the electrical wiring diagram applicable to the model installed.
Applicable to the T and H version:
Insert the cores of the power cord into the corresponding holes of the terminal strip. For ease of use, lift the levers on the clamps.
•
Verify the tightness of the cable cores in the terminals.
•
Check if the fan is firmly installed and correctly wired.
Applicable to the T and H version:
Set the stop delay time and the humidity sensor sensitivity level using the potentiometer knobs on the controller (
7
).
•
Check the tightness of the power cord.
- The power cord must be secured so that in case of flooding there is no ingress of water to live parts.
•
Place the electric cover (
4
) and secure with the screws (
3
).
•
Slide the handles of the front panel (
1
) into the holes of the impeller cover (
2
).
•
Place the front panel and the impeller cover on the front of the fan in a counterclockwise direction by approx. 5°. Then turn clockwise until the latches are locked.
ATTENTION! A rotating impeller can crush your fingers!
It is forbidden to start the fan without a protective mesh against touching the moving parts!
15
EN