F
ull- Automatic Programming:
This function is used to cook after a certain period of time, within
a certain duration. The food to be cooked is put into the oven.
The oven is adjusted to the desired cooking function. The oven
thermostat is adjusted to the desired degree depending on the
dish to be cooked.
First; keep pressing on the MODE button until you see “stop” on
the timer screen. When you see “stop” on the timer screen, the
symbol (A) will begin to flash. Adjust the cooking period for the
food you wish to cook, by using the (+) and (-) keys while timer is
in this position. Some time after the adjustment operation is
completed, the day’s time will appear on the screen and the
symbols (A) and
will begin to continuously light on the
screen.
A cooking period between the time range of 0 and 10 hours
can be set.
Second; keep pressing on the MODE button until you see “end”
on the timer screen. When you see “end” on the timer screen,
the symbol (A) and the day’s time will begin to flash, with the
addition of the cooking period. Adjust the finishing time for the
food by using the (+) and (-) keys while the timer is in this
position. Some time after the adjustment operation is
completed, the day’s time will appear on the screen and the
symbol (A) will begin to continuously light on the screen.
You can set a time which can be up 23.59 hours after the
time obtained by adding the cooking period to the day’s
ti
me.
The oven will start operating at the time calculated by deducting
the cooking period from the set finishing time, and will stop at
the set finishing time. The timer will give an audible warning and
the symbol (A) will begin to flash. After bringing the oven button
and oven thermostat button to 0 position, pressing any button of
the timer will end the audible warning. Also, the time will be
brought to manual use function.
-
+
MODE
A
En d
-
+
MODE
A
du r
Sound Adjustment
While the timer shows the time of day; if the
(-)
button on is kept
pressed for 1-2 sec.,
it
will give an audible signal beep. After that
each time the
(-)
button is pressed,
it
will give three different
types of signal beep. Do not press any further buttons and
it
will
save the last selected signal type.
