Some products may not be available in your country, please contact our distributor for more details
Some products may not be available in your country, please contact our distributor for more details
6.OSD - Zones and Privacy Mask
17
Zones
You can define the zones in the whole PT range up to
8 zones. When the display setting “Zone Label” is
activated, its label will be displayed on the screen.
The defined ranges of the zones should not be
overlapping.
ZONE NUMBER:
Supports up to 8 zones.
SET LEFT LIMIT:
Left boarder of the current zone.
SET RIGHT LIMIT:
Right boarder of the current zone.
CLEAR ZONE:
Delet the current zone.
EDIT ZONE LABEL :
Changes the label (name) of the
current zone.
ZON ES
ZONE NUMBER 1
SET LEFT LIMIT
SET RIGHT LIMIT
CLEAR ZONE
EDIT ZONE LABEL
BACK
EXIT
Privacy Mask (Window Blanking)
Privacy Mask is used to protect the privacy area that
should not be displayed once the camera is pointed
on it, such as lavatory areas or the operation desk of
an ATM machine. This might be mandatory required
by local law regulations. The Speed Dome supports
up to 24 private masks (depending on the installed
camera module; please contact your local sales
representative for more information).
Hitachi camera modules
:
8 masking areas
Sony Camera modules:
up to 24 masking areas
(except the 45 series provides only 8)
LG,CNB Camera modules:
no masking function
WINDOW NUMBER:
Mask number.
EDIT WINDOW:
Edit position of the mask using
the
keyboard’s joystick. Presse IRIS-OPEN to save.
ENABLE WINDOW:
Shows the mask on the screen.
CLEAR WINDOW:
Deletes the mask.
WINDOW BLANKI NG
WINDOW NUMBER 01
EDIT WINDOW
ENABLE WINDOW OFF
CLEAR WINDOW
BACK
EXIT
7.PROTOCOL SETTING
Protocol Setting
This procedure is needed if a connection of the
telemetric control with the keyboard device is
desired. You need to setup the dome address and
protocol settings.
The speed dome support multiple communication
protocols. The settings can be changed by
rearranging the DIP-Switches on the rear side of
the connector board as illustrated.
Please use the following table for detailed
information.
Baud rate
DIP 7
DIP8
2400 bps
0
0
4800 bps
1
0
9600 bps
0
1
19200 bps
1
1
SW 1:
Represents the dome’s address in binary form.
Please refer to the list on the next pages for
reference.
SW 2:
Used for protocol settting and baud rate.
DIP 1 to 6 : Protocol settings
DIP 7 and 8:Baud rate settings
B02
0 0 1 1 0 0
DIAMOND
1 0 0 1 0 0
HUNDA
1 0 1 1 0 0
KALATEL
0 1 0 1 0 0
LILIN
1 1 0 1 0 0
MOLYNX
0 0 1 0 0 0
PANASONIC
1 1 1 0 0 0
PELCO (D/P)
1 0 0 0 0 0
PHILIPS
0 0 0 0 0 1
SAE
0 1 0 0 0 0
SAMSUNG
0 0 0 1 0 0
SANTACHI
0 1 1 0 0 0
UNIVISION
0 1 0 0 0 1
VCL
1 1 0 0 0 0
VICON
1 0 1 0 0 0
AD
0 0 1 1 0 0
Protocol / DIP
1 2 3 4 5 6
