DVR User Manual
8
Operation processes with remote controller to control multi-DVR
The device ID of the DVR is 0. It‟s not necessary to reset the device ID when a remote is not
be used to control a single DVR. However when controlling multiple DVRs with multiple
remote controllers, you would need to configure the device ID. Please refer to below steps:
Step 1
: Activate remote controller to control DVR: Turn the IR sensor of the remote controller
towards the IR receiver on the front panel, press the number key 8 twice, then input device ID
of the DVR to be controlled (Range from: 0-65535; the default device ID is 0) and then
press ENTER button to confirm.
Step 2
: Check the device ID of DVR from System Setup
Basic
Device ID. You can also
set multiple DVRs with the same device ID. However, this can cause interference if the DVRs
are kept close to each other.
2.5 Control with Mouse
2.5.1 Connect Mouse
It supports USB mouse through the ports on the rear panel.
If mouse is not detected or doesn't work, check below steps:
1. Make sure the mouse is plugged in the USB mouse port.
2. Try with a good know mouse.
2.5.2 Use Mouse
During live:
Double-click on any camera window to see the full screen. Double-click again to return to the
previous screen.
Right click to reveal the control menu on the screen. Right click again to hide the menu.
In Configuration:
Click to enter a particular option. Right click to cancel the option or to return to the previous
menu.
In order to input a value in a particular screen, move cursor to the input box and click. An
input window will appear as Fig 2-4. It supports digits, alphabets and symbols input. Click
Shift button to input Capital letters and symbols; click Shift button again to return.
It supports mouse drag. Take setting up motion detection area for example: Click customized,
hold down the left button and drag to set motion detection area.
