MENU
DESCRIPTION
FUNC. SET
MOTION
DETECTON*
SCREEN
ALARM
Select
ON
to enable motion detection or
OFF
to disable this
function.
PAD
OUTPUT
No function.
SECTION
Select the area for motion detection.
SENSITIVITY
Select the sensitivity for motion detection from
LOW
,
MIDDLE
and
HIGH
.
You’ll see a default masking area on the screen.
PRIVACY
MASKING
Select
ON
/
OFF
to enable / disable this function.
COLOR
Select a color to show area masking.
HEIGHT /
WIDTH /
LEFT /
RIGHT /
TOP /
BOTTOM
Set the area to mask.
SYSTEM SETUP
OSD COLOR
Select the color for this OSD display.
OSD BG
Select the background color for this OSD display.
RESET
FACTORY MODE
Enable to restore the camera parameters to factory default values.
The camera image will flash once when the reset is done.
SAVE & EXIT
SAVE & EXIT
Select
YES
to save and exit, or select
NO
to exit without saving.
* The function here is for this camera only, and the detection log will be not noted in the DVR.
FAQ
Q: The image quality at night is not good. I can see some red dots at the edge of the image. What should I do?
A: Please go to the camera’s parameter setting page as described in the section of “CAMERA PARAMETERS”, and select
EXPOSURE
->
AGC
to change the value to
MIDDLE
, and check again.
